Northern Park Trails in Rocky Mountain National Park

Northern Park Tails

in Rocky Mountain National Park

Select a trail below for a complete description, photos, maps, profiles, and more.

Short Hikes

Alluvial Fan -
0.3 miles

Tundra Communities -
0.6 miles

Moderate Hikes

Gem Lake -
1.7 miles

Beaver Mtn -
4.6 miles (loop hike)

Deer Mountain -
3 miles

Bridal Veil Falls -
3.1 miles

Longer Hikes

Balanced Rock -
4 miles

Ypsilon Lake -
4.7 miles

Deer Ridge -
10.5 mile loop

Lumpy Ridge -
10.7 mile loop

Lawn Lake -
6.3 miles

Lost Lake -
9.3 miles

Challenge Hikes

Backcountry navigation skills required
These are sensitive areas, travel carefully

West Creek Falls -
2.4 miles

Chapin, Chiquita, Ypsilon Mtns -
4.2 miles

Crystal Lake -
7.5 miles

<< Main Page

Trails by Location >>

About Hiking in Rocky Mountain National Park

Follow all National Park regulations,
as posted at trailheads and on the official Park map. Click Here
Be sure to carry some water,
if you're planning to be gone for a while. Although the mountain streams are cold and clear and appear clean, abundant wildlife pass over these streams and may leave pathogens that could give you intestinal giardiasis. It's best to bring your own water.
Bring something warm to put on.
The weather in the mountains is not predictable. You can easily start off on your hike warm and sunny and return cold and wet. Afternoon thunderstorms are common and temperatures can vary considerably. It's always best to be prepared.
Pay attention to the weather.
Thunderstorms can pop up quickly and could be hazardous if you're in a bad spot; be ready to to take cover. Sometimes these thunderstorms pass quickly, followed by bright sun and fresh air.
Refrain from feeding the wildlife.
In some places, the little chipmunks and birds are so used to being fed, they will practically insist on a treat. It is illegal to feed any wildlife in the Park, even a friendly deer. Do not approach wildlife. This is their home; we should allow them to live here as undisturbed as possible while we watch.

Trail miles:

Most of the hikes listed show the one-way distance from the trailhead to a particular destination and the return distance needs to be added. In a few cases, the miles given are for the whole hike, for example, loop hikes or through-hikes (where the hike ends at a different trailhead then where you started).

Calculating hiking pace:

You can gage how much time you will need to complete a hike if you know the speed at which you hike. Most people will hike between 1-2 miles per hour. Start by seeing how long it takes to walk a 1/2 mile loop. Don't forget to factor in breaks, too.

About the maps:

The maps included with each hike are the most current USGS topographical maps. However, there are cases where the map may show old trails and so they should be used with caution and only as a general guide.

These Trail Pages made possible with Support from our Local Partners.
When in Estes,
Shop Locally!!